BannerFans.com
Showing posts with label trailer. Show all posts
Showing posts with label trailer. Show all posts

Saturday, July 21, 2012

NO voltage on Trailer Sockets?

VEHICLE: 2008 Volkswagen Passat Estate.
Engine Model: 2.0 TDI 140.

PROBLEM: No voltage on Trailer wiring sockets on rear side of car.Its a 7 Pin socket trailer.

TROUBLESHOOTING SOLUTION:--

Noticed such cases at out garage few times.
On one of such case the customer noticed the problem after his tow bar electric installed in the vehicle.
On that same case the problem was blown out  fuse for the smart relay, which is on a flying lead.

Yes its possible,that in your case the fuse must not be the same but it indicates problem with fuses.
Any of the fuse or fuses are blown out and causing this issue.

Inspect the fuses.
Below are the details for the fuse box located on your car model.

There are multiple fuses depending on your fuse box , which is depending on your level of spec on car, so you will have to check all possible areas.

Fuse box number 1 passenger side under bonnet:

  • Check / inspect the fusible links .Locate Fusible links on passenger side under bonnet next to battery .The numbers SA 4 , SA 5 start from left hand side front of fuse box and count along until you come to fusible links 4 and 5, next SB3,4,30,49, SB3= 25A, SB4=25A, SB30= 50A, SB49= 50A, same fuse box as before.

Also  look at fuses on top in same fuse box, you will see No of fuses beside fuse usually starting with an F.

Fuse box number 2 side of dash panel( driver side)


  • For this fuse box  you will have to remove cover on side of dash panel, again fuses are No on plastic part of fuse box, SC6= 5A, SC28= 20A, SC38 = 15A.
Check the fuses in the fuse box.

Fuse box number 3 located in boot area on left hand side behind trim panel.

  • In these fuse box check fuses SF1 = 30A, start from left hand side and SF1 is 1st fuse.
Properly check each and every fuse and fusible links in the fuse box.Yes its time consuming to inspect each and every fuse,but that's the only procedure to confirm.
The problem is most probably the fuse and next possibility is wiring,but that's rare.


These details will help.
Thanks.


What wire to connect to hook up trailer on Nissan Sentra?

http://technoanswers.blogspot.in/2012/02/what-wire-to-connect-to-hook-up-trailer.html

Headlights will not turn OFF on Ford expedition and car trailer?

http://technoanswers.blogspot.com/2012/01/headlights-will-not-turn-off-on-ford.html









Friday, July 13, 2012

Dodge Trailer Park Lights not working?

TRAILER PARK LIGHTS NOT WORKING

2003 Dodge ram 2500 cab with 5.9L Diesel engine.

The Park light for dodge truck is working fine but trailer park lights not working.Trailer is factory wired.


HOW TO START TROUBLESHOOTING THIS PROBLEM?

Start with fuse,first check the fuse controlling trailer park lights.Its a 20amp fuse.
If fuse is shorted,then replace the blown fuse and it will work.
But if fuse is checked ok,then inspect the trailer plug connector.If all other brake lights and tail lights working for trailer and only park light is not working then trailer plug must be fine.But still remove and clean the trailer connector.
Also test the park lights terminals on fuse to see if has any voltage.

HOW TO TEST VOLTAGE ON PARK LIGHT FUSE?

It has to be done with volt meter.
You can also use test light.
NOW with that,
Ground the alligator clip of the test lamp or the black voltmeter lead, whichever you're using. If you're using a meter set it to 20v DC.
After that,
Turn the park lamps ON and use the red test lead or the test light probe and touch each of the two small open terminals on top the fuse. See if the voltage is there on one, two, or no terminals have voltage.

IF you get voltage on both terminals then continue further troubleshooting as mentioned below.

Go underneath the vehicle.You will see two electrical connectors.One is 14 way connector and other is 8-way connector. There just behind the left front wheel, behind the wheel well liner.Yow will see the  large rectangular connector. You have to view 8-way connector.There you locate black/orange wire. On the back side of the connector toward the rear of the truck, pierce the wire's insulation and see if there is power there with the park lamps on. 
Either the wire is bent or its got loose or dirty.Properly inspect the black/orange wire.

After testing is done seal the hole up with silicone,electrical tape, etc.

FINAL RESULT:

Thanks.
Orange/black wire was loose and reconnecting it solved the problem.The trailer park lights are now powering up.

This details will help.
Thanks.

Users Who Viewed This Problem Also Viewed:

Headlights will not turn OFF on Ford expedition and car trailer?

http://technoanswers.blogspot.com/2012/01/headlights-will-not-turn-off-on-ford.html

Hybrid For Trailer?

http://technoanswers.blogspot.in/2012/04/hybrid-for-trailer.html

What wire to connect to hook up trailer on Nissan Sentra?

http://technoanswers.blogspot.in/2012/02/what-wire-to-connect-to-hook-up-trailer.html

No parking lights and headlights not turning OFF?

http://technoanswers.blogspot.com/2012/01/no-parking-lights-and-headlights-not.html

Parking light stay on constantly?

http://repairhelpcenter.blogspot.com/2012/01/parking-light-stay-on-constantly.html