BannerFans.com
Showing posts with label dashboard. Show all posts
Showing posts with label dashboard. Show all posts

Saturday, October 13, 2012

Ford focus dashboard light will not turn on


The vehicle starts fine but the dashboard lights will not turn ON.

These types of problems are noticed on many vehicle brands.

On these particular case the customer noticed issue on his 2002 ford focus.The dashboard lights were not coming ON.

On such cases the problem is either faulty dimmer switch or its issue with faulty headlight switch or its faulty /short wiring or its blown fuse in fuse box.

Just have a look in fuse box,if any fuse is shorted the faulty fuse needs to be replaced.


In such cases no dashboard lights will work.
First try adjusting the dimmer switch dial.If its got set to its lowest setting by mistake,then getting it set to high will solve the issue.

But if that is not helping, then that sounds like the dimmer switch is bad and it needs to be replaced. Its the switch used to adjust the brightness of the lights on the dash and the radio ECT.

On some car modes,headlight switch and dimmer switch is one common switch and on some vehicles there are two switches.One for dimmer and other acts as head light switch.So if on your car,if there are two switches and you have already replaced dimmer switch,then try replacing headlight switch.


 It is possible the headlight switch is bad if the fuses are ok.

To confirm the problem before replacing switch,you can testy the switch with voltmeter.

At the back of switch there is a orange/blue wire.A another orange wire with black stripes and one green wire with black stripes.


You need to check the orange wire with the black strip and the green wire with the black stripe they should both have power with the key on.

In the same way check the orange/blue wire with key on.If there is no power on these wire then headlight switch is faulty and needs to be replaced.

But if you replace the switch and still the same problem is there with new switch,then its issue with wiring.So before directly replacing the switch,inspect and test the wiring.

If you have power going in and nothing going out then it is switch problem, unless the wire is broke that goes to the interior lights.So to confirm  check the wiring at the connector.


The orange and blue wire goes to the lights on the dash. It is possible you have a short to ground somewhere to the dash lights if it is blowing the fuse.

To solve the short issue in wiring,

Try these simple procedure.Run a new cable, or put you ohm meter on the lowest setting and touch the orange blue wire and put the other end to ground. Suppose you get low resistance then there is a short to ground and you will need to unplug the wiring harness until you get high resistance showing were the short is located.

These details will help you to confirm what the problem is.

Either its switch or wiring or its fuse problem.

Thanks.


Users Who Viewed This Problem Also Viewed:

2002 Ford Windstar: Brake Warning Light ON dash?

http://schematicsdiagram.blogspot.in/2012/06/2002-ford-windstar-brake-warning-light.html

ABS & Brake lights warning indicator steady on dash and speedometer not working for Dodge Ram?

http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html

Battery Light and ABS Light on Dash

http://whoisbyme.blogspot.in/2012/07/battery-light-and-abs-light-on-dash.html

Service 4wd warning light on Dash?

http://howtobyme.blogspot.com/2011/11/service-4wd-warning-light-on-dash.html

2001 Chevrolet Tracker: Headlights and Dash lights Pulsating?

http://whoisbyme.blogspot.in/2012/06/2001-chevrolet-tracker-headlights-and.html

Heater makes clicking noise under dash on Ford Explorer?

                         

Clicking noise under dash and front defroster not working?

http://technoanswers.blogspot.com/2012/01/clicking-noise-under-dash-and-front.html







Wednesday, July 4, 2012

Random Warnings On Dashboard with NO Error Codes stored


Dashboard Tone randomly and Loose Gas Cap message comes up.This message goes off after few minutes.But again same problem exist.
Problem noticed on 2006 Jeep Liberty 3.7L.

The GAS-CAP message comes up on odometer and Dash board makes Warning Sounds.

WHAT SHOULD I START WITH?


First inspect the gas cap.If its loose or worn out of dirty.First try cleaning the gas cap and reuse same gas cap and see if that helps.But if problem is same then replace the gas cap with new Gas cap and see if that is helping to take care of this problem.


  • ACTUALLY GAS CAP IS REPLACED AND THERE ARE NO ERROR CODE STORED.

HAVE YOU EVER DEALT WITH THIS PROBLEM BEFORE?



YES,at out garage we have noticed this same as well as identical problems.This isn't unheard of and is something I've personally dealt with numerous times on a Liberty and other model vehicles too. It's not uncommon to have random warnings come up with no codes stored, the reason there are no codes stored is because there are no actual problems.

SO WHAT IS PROBLEM IN MY CASE?

This can happen with the gas cap warning, which is most common, but can happen with any warning lights. What's happening is the body control module (BCM) is sending false messages to the instrument cluster to turn these warnings on.There is issue with BCM.

IS THERE ANY TEMPORARY FIX?


A temporary fix when it's acting up is to disconnect the battery and let the BCM power down.These procedure resets complete electrical system of vehicle.
If it hasn't been done already I would recommend making sure the BCM software is up to date.

ALL SOFTWARE'S ARE UPDATED,ANY OTHER PERMANENT FIX?

If the software is up to date or updating it doesn't take care of the problem then the permanent repair is to replace the BCM. There was a possible software change for this mentioned while these problems were going on a few years ago, but BCM replacement ended up being the permanent repair.So getting the Body Control Module replaced will help.

OK,BUT WHERE IS BCM LOCATED?

On,2006 Jeep Liberty model,The BCM is fitted to the back side of the fuse box in the dash and controls many of the electrical features in your Jeep.

WHAT IS THE WORKING OPERATION OF BCM?


There are many other modules in your vehicle.The Ignition module,Engine control module,transmission module, etc.The Body control module acts as the communication gateway between modules because some of them communicate at different speeds, but need to communicate with each other. This is where the issue with the false messages to the instrument cluster comes in, because the BCM does the interpretation from other modules and is what sends the messages to the cluster.

This details will help.
Thanks.


Users Who Viewed This Problem Also Viewed:



2005 Lexus RX330: Engine Warning Light and VSC Lights is ON?

http://technoanswers.blogspot.in/2012/05/2005-lexus-rx330engine-warning-light.html


2008 Toyota Highlander: ABS warning light Blinking and OBD Error codes Coming?

http://technoanswers.blogspot.in/2012/05/2008-toyota-highlander-abs-warning.html


2007 Lexus GX470: All warning lights Comes ON and Clock Resets While Starting?

http://whatisbyme.blogspot.in/2012/05/2007-lexus-gx470-all-warning-lights.html


2007 Lexus GX470: All warning lights Comes ON and Clock Resets While Starting?

http://whatisbyme.blogspot.in/2012/05/2007-lexus-gx470-all-warning-lights.html


2007 Toyota RAV4: Battery Warning Light Flashing on Dash?

http://whatisbyme.blogspot.in/2012/05/2007-toyota-rav4-battery-warning-light.html



All control panel warning Lights are steady ON?

http://whatisbyme.blogspot.in/2012/04/all-control-panel-warning-lights-are.html


For All types of Car models and brands help 
Go to Newly Launched

FREE Car repair guide? 
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html 

& 
Complete Car repair Help FREE? 
http://repairhelpcenter.blogspot.in/2012/03/complete-car-repair-help.html